Part
Oven Control Board
Product Rating
Customer
Daniel from MN
Problem
Frigidaire gas stove! F10 problem
Tools
1/4” nut driver
Repair & Advice
Had to reset stove to often! Problems could be from 3 things, wiring, temp probe, or control board. Unplug stove and slide stove out watching fuel line not to pull stove out to far. Remove back covers with 1/4” nut driver, check wiring and connections,check temp probe, should be about 1100 ohms. If those 2 check out your control board is bad. I was told the control board last about 10 years on a average. Unplug wire from control board and remove 4 corner screws, clock face is glue on to control board which you have to remove if your reusing it, be careful removing don’t rush it. Put clock face on new control board,install,plug in wire connection, assemble back covers, push stove back and plug in power cord. If control boards acts funny or shuts off! Don’t panic, unplug power cord for about 5 minutes to reset control board and than plug back in.
Story submitted on April 17, 2019
Part
Oven Control Board
Product Rating
Customer
joe from PA
Problem
Stove not working
Tools
Basic
Repair & Advice
Ordered and replaced control board
Story submitted on February 26, 2019
Part
Oven Control Board
Product Rating
Customer
Bill from NY
Problem
Control board failure.
Tools
Nut driver.
Repair & Advice
Very simple repair.
Story submitted on October 8, 2020