Part
Heating Element Assembly
Product Rating
Customer
Brian from WI
Problem
Dryer would not heat.
Tools
1/4 inch driver and needle-nosed plyers.
Repair & Advice
Dryer stopped producing heat. Used my meter to determine it was the heating element. Purchased a new one from Parts Dr and it arrived within a few days and took me no more than 15 minutes to install. Dryer works perfectly again! This is the second time I've used this company for parts and advice, btw. Ordered a part for our stove a year or two ago, and it also arrived quickly and worked perfectly. 10/10 would recommend.
Story submitted on April 14, 2020
Part
Heating Element Assembly
Product Rating
Customer
Edward from AZ
Problem
Dryer would not heat up. Just ran cold.
Tools
Small nut driver. Pliers. Drill with small bit
Repair & Advice
Remove back panel of dryer. Locate heater coil lower right corner. Remove wires and temp guage from old unit and apply to new unit. Three screws hold unit in place. Replace back panel.
Story submitted on January 25, 2019
Part
Heating Element Assembly
Product Rating
Customer
Keith from NC
Problem
Dryer would not heat up. Heating element has burnt out.
Tools
Multimeter, power screw driver, gloves
Repair & Advice
Checked for short in all thermostat connections with multimeter. Since all thermostats were good, determined heating element needed to be removed to check for short on heater coil. Found the heating element needed to be replaced.
Story submitted on October 13, 2015