Suspension Spring (Set of 6)

Suspension Spring (Set of 6)

Brian from NV

Washer was always out of balance. Seemed to shake a lot.

Screwdriver, putty knife, and channel lock pliers.

Tape the lid close with painters tape. Pop the clips holding the lid with a putty knife. Remove the screws in the top front corners the hold the front panel. Remove the front panel. Springs are accessable with the front panel off. Removing the old springs was not hard with a channel lock. Installing the new springs was a bit more difficult. I had my son hold the drum tward the spring I was installing. I couldn't get the new springs on without help. Replacement took less than an hour. So far seems to shake less.