Part
Cold Water Inlet Valve
Product Rating
Customer
Gerald from TX
Problem
Water entering went no in use.
Tools
Pliers, screwdriver.
Repair & Advice
Most difficult part of repair was moving washer away from a wall. It took 3 or 4 tries to get the screw holes to align went reinstalling the top panel.
Story submitted on June 12, 2021
Part
Cold Water Inlet Valve
Product Rating
Customer
Douglas from CA
Problem
Leaking solenoid valve
Tools
Torx driver & standard pair of pliers.
Repair & Advice
Very simple to replace. Remove two screws and slide top cover back (about a half inch) and lift up, away from machine. Valve is located in upper-rear corner of machine. Press small locking tab on electrical connection and pull to unplug wire connection. Use pliers to squeeze hose clamp open and slide back on hose. Remove small rubber hose/hoses from valve. Lift clip on valve at back of machine panel and slide sideways while pulling inwards to remove.
Story submitted on October 16, 2019
Part
Cold Water Inlet Valve
Product Rating
Customer
Ernesto from CA
Problem
No cold water coming into the washer
Tools
Pliers, screw driver
Repair & Advice
Watched a video. Unplugged machine, shut off water, removed top, removed and replaced part. Diagnosing the issue took the most time. Finding the part also took some time. Replacing the part was quick.
Story submitted on June 22, 2021