Part
Relay Control Board
Product Rating
Customer
John from MD
Problem
I have KitchenAid 42" built-in refrigerator (KSSO42QTX03). Control panel buttons for ice/water dispenser on freezer door were working intermittently. Ice maker was making ice intermittently. Ice dispenser door did not close fully after dispensing ice. I read this can be caused by insufficient voltage coming from this control board. Otherwise fridge was working fine.
Tools
Simple tools most will have at home (screw driver, socket wrench, pinch nose pliers).
Repair & Advice
This control board is located in space above refrigerator. Front cover of machinery area must be removed with 1/4" socket. Control board is on right hand side behind several wire harnesses running across in front of it. Best thing to do is open the 4 or 5 wire connectors running in front of it to make room for removal. Mark the connectors to ensure you connect together correctly after replacement of board (but I think each connector is different enough that they can't be reconnected wrongly) . Unplug wires connected to board itself. Board is attached with four tiny white push on fasteners at each corner. Use pinch nose pliers to squeeze each pin on front side of board while simultaneously pulling board forward off the pin, leaving pin in place. Simply push new board back onto pins until hear a locking sound. Reconnect wires and replace cover. Simple except for lack of maneuvering space around all the wires running in front of the board making it delicate removal and taking more time.
Story submitted on March 8, 2022
Part
Relay Control Board
Product Rating
Customer
Gary from TX
Problem
Water dispenser beeps no water, Ice dispenser door would not open / close properly
Tools
1/4" driver, pliers
Repair & Advice
Read every blog possible about my water dispenser beeping and no water. Replaced dispenser controller board in door. Intermittent results then nothing. Replaced control valve, no result, replaced relay control board every thing came to life and started working perfect, except during all this the motor on the ice dispenser died. Easy fix though.
Story submitted on April 27, 2019
Part
Relay Control Board
Product Rating
Customer
Michael from WI
Problem
ice maker intermittent. water intermittent. limited ice production. control buttons on the door intermittent
Tools
hand tools. basic. need electrical common sense
Repair & Advice
Parts Dr. has be a good source for me. This project was 90% successful. All the intermittent problems are resolved. The ice cubes are dispensing small. ice maker is new too. still much happier.
Story submitted on February 21, 2023