Part
Lid Switch Assembly
Product Rating
Customer
James from IL
Problem
washer would not agitate. Flashing code stated door switch issue.
Tools
wire cutters/crimpers
Repair & Advice
parts was exact down-to-the-wire colors. Unplugged washer. Cut the old switch off. Strip the wires back on cut wires and new switch. Use butt splices to connect the new switch to the cut wires. Plugged in washer and tested. Every working good again.
Story submitted on October 15, 2021
Part
Lid Switch Assembly
Product Rating
Customer
Mike from AL
Problem
Broke the original switch taking machine apart to change the transmission. This replacer was easy.
Tools
Water proof butt splices, crimpers
Repair & Advice
Broke the switch, bypassed the switch, after a couple loads of laundry the machine would not run. The inverter realizes the switch did not function so it stops the machine from running.
Story submitted on October 19, 2016
Part
Lid Switch Assembly
Product Rating
Customer
James from CA
Problem
Washer would not drain or spin.
Tools
1/4 " hex driver, wire snips, crimp connectors and crimper
Repair & Advice
Washer didn't get enough water for a cycle, washer wouldn't drain right, washer wouldn't finish a cycle, washer wouldn't spin... time to replace the washer or the wife???
Replaced the water pressure level switch and then replaced the control board. Then I replaced the lid switch. Like a brand new washer, it runs great in all cycles. Wish I had started with the lid switch. Would've saved time and money! Thanks Parts Dr.com ! Good parts and fast shipping.
Story submitted on March 6, 2019