- Lid Lock Quick Release
CustomerGreg from LA
Would not spin or agitate
1/4 inch Nut driver, phillips screwdriver, putty knife.
Repair & Advice
Unplug power from washer. Turn water valves off to washer. Remove water hoses at the back of washer. Have a bucket handy to catch any excess water from hoses. Remove phillips screws on back corners of control panel, pull the control panel forward toward front of washer just a little to disengage it from the body of washer. Gently flip control panel towards the back of machine. Then remove two 1/4 hex nuts from each side of of washer cover lid. One located under/near starting capacitor and then on the other side near the top right of washer lid. Using putty knife about 8 inches in from corners of front of machine, push retaining clips in to disengage lid cover. Remove white plastic bevel around top if lid switch opening. Unplug wire connect to lid switch located under lid cover. Squeeze plastic retainers on lid switch located under the lid to remove switch. Reverse procedure to complete installation.