Wire Harness

Wire Harness

Richard from TN

Rats ate the wiring

Screwdriver

Very easy replacement

Wire Harness

Richard from OR

GE Dishwasher GDT695SGJ0WW: Service LED is on solid green. No user control lights come on. No lights on user control panel. AC power is verified correct. Pressing and holding the Select Cycle and Start buttons does NOT respond with display coming on. Door latch switch measured zero ohms so has continuity when door is closed, and does not when door is open. Flood switch has continuity when actuated.

Nut drivers, Multi-meter

Recently there were no lights on user control panel but pushing the reset button on the thermal sensor brought it back to life. However, later the problem reoccurred and pushing the reset button did not work. This thermal sensor is part of the AC Harness Assembly Part Number WD21X24096. Two of the wires go from the Electronic Control Board WD21X24901 to the heating element WD05X24776. It measured zero OHMS on both leads so it has continuity, tested both plugged in and unplugged. Resistance across one wire to the other was 16.4 OHMS plugged in. The heating element also measured 16.4 OHMS by itself (unplugged). Research revealed that with a completely open circuit the thermistor is likely to be faulty. I found a “thermistor output table” in the service information and got thinking that since it measured ZERO OHMS on both leads perhaps it went bad. However, the new one also measured zero ohms. I installed it anyway but the symptoms did not change. SOLVED: Replacing the User Control and Display Board WD21X23462 fixed it.