Part
Control Board and Overlay
Product Rating
Customer
Laura from TX
Problem
Control Panel stopped working.
Tools
Screwdriver
Repair & Advice
Unscrewed outside panel, disconnected wires, removed old panel and reconnected new panel.
Story submitted on November 10, 2023
Part
Control Board and Overlay
Product Rating
Customer
Robert from LA
Problem
Some digits in display did not light- this happened after a power hit
Tools
Phillips screwdriver, nut driver
Repair & Advice
Turn power off to oven, remove 2 screws at bottom of panel, carefully pull panel away from oven and disconnect cables. Put panel face down on a towel to prevent damage, remove this unit by removing screws, replace unit and put screws back, reconnect cables, put panel back, screws at bottom. Power oven back on. That's it.
Story submitted on April 10, 2022