Part
Glowbar Igniter
Product Rating
Customer
Nicholas from NY
Problem
Gas oven not heating
Tools
Socket set
Repair & Advice
The glow bar itself was easy to remove but the wire harness was in the back of the oven. It was run through a small hole in the oven frame which didn’t line up with the hole in the console containing the wire harness. I cut 24” of 16ga steel wire, tied it to the harness for glow bar, using it as a stylet I ran it from inside the oven through the two holes that didn’t line up correctly. Around the back of the oven I was able to continental feeding the 16ga wire pulling the attached harness through and attaching it to power. Works great. Though my first order of the part arrived broken they sent a quick replacement and I’m very satisfied with the service and quality of the part. Thank you.
Story submitted on October 13, 2021
Part
Glowbar Igniter
Product Rating
Customer
Paul from CT
Problem
Top oven would not ignite.
Tools
1/4 inch socket snd screwdriver
Repair & Advice
My first part you sent me was broken in the box. I didn't realize that til i took stove apart and could see what the ignitor looked like. Then i could see prongs sticking out 3 inches and new part was not. Turned box upside down and out falls pieces. I submitted problem and immediately you sent me new part. Hooray!! Quite a job replacing part rerouting wire through back of stove.
Story submitted on January 30, 2024
Part
Glowbar Igniter
Product Rating
Customer
Gabe from WA
Problem
Oven was not heating up
Tools
Nut driver, screwdriver
Repair & Advice
Toughest part was threading the wire through the firewall in back. Recommend taping it to the old one when pulling it out.
Story submitted on January 11, 2022