Part
Detergent Dispenser
Product Rating
Customer
Edward from IN
Problem
Soap dispenser would not stay closed
Tools
Small flat head screw driver, torex screw driver, pliers
Repair & Advice
There is a great video on line. Turn the power off first. Torx driver to remove the outside cover of the door. All the screws are not the same length so pay attention to their location.Unclipping the wire harness from the door was tough. Take your time. Flat head to bend dispenser retaining clips out. After bending the clips out to release the dispenser you must straighten them out while leaving them bent slightly inward. Clean where the gasket seats. When installing the new dispenser, make sure all the clips snap into place. You will need to push hard on the dispenser on the inside while supporting the door on the outside. Reattach the wires. Mine leaked the first time so I had to do it twice. I did not push on the dispenser hard enough to completely seal it to the door, all the clips were not fully engaged. Second time thru I left the outside cover off and ran a short wash cycle to make sure it did not leak.
Story submitted on November 3, 2023