Part
Rear Panel
Product Rating
Customer
Granville from FL
Problem
Completely out of balance.
Tools
1/4 inch drive set, screw drivers and drill.
Repair & Advice
The back plate where the motor is mounted cracked causing the drum to shake and was way off balance so ordered this plate, removed old plate and installed the new plate had to drill one hole but other than that it was a good fit, have to remember the orientation of motor when removed and make sure you replace it in the exact location or it will rub and not rotate drum. Other than that it was a good DIY repair that would have cost more than the machine was worth if a service tech would have been called and the price of the part was way less than any other appliance parts store, A +.
Story submitted on October 13, 2023
Part
Rear Panel
Product Rating
Customer
Jacob E from NC
Problem
Rear bulkhead in our Maytag Dryer had sharp nics. It was catching our clothes and ripping them.
Tools
Drill with bits, wrenches, screw driver and smart phone used for before pictures and watching videos.
Repair & Advice
Take pictures of wiring. Did I say take pictures.
Story submitted on November 23, 2021