Dispenser Assembly

Dispenser Assembly

Anthony from NY

dish washer

screwdriver

fix perfect

Dispenser Assembly

Vincent from CT

Soap dispenser door broke

screw driver

It wasn't too hard to change the part out, you just need to watch what your doing. I did it as easily as possible without disassembling too much.

Dispenser Assembly

Nicholas from NM

Soap dispenser was opening intermittently.

Torx, flat blade screw driver

I watched a video showing the removal and replacement of the dispenser prior to tackling the job myself. My dishwasher has a door handle which, surprisingly did not have to be removed from the exterior door panel (I figured this out after the fact). Once you remove all the screws along the perimeter, the door panel will lift off. There are 6 screws that hold the dispenser to the interior door assembly. After removing the dispenser I cleaned the area and the mounting bracket inside and out including using a wire brush on the bracket. You may need to use a small flat blade screw driver to disconnect the electrical connection. I installed the new dispenser making sure to start all 6 screws and ensure the dispenser was centered in the opening. Tightened the mounding screws to make sure the rubber seal of the dispenser was in full contact with the door panel. Reinstall the exterior door panel, turn the power back on, and did a test run. Viola! Working dishwasher! Far cheaper than hiring someone else to just swap the parts.