Oven Broil Element

Oven Broil Element

Jacob from GA

Heating element failed

Philips screwdriver

There are only four screws to remove. First remove the two screws on the back wall of the oven and then the two screws holding the element to the top of the oven. Once the four screws are removed gently pull the element forward from the back wall of the oven to expose four wire connectors. Carefully disconnect the wires while ensuring the wires do not fall back into the holes. Once the wires are disconnected reverse the process to install the new element. You may need an extra pair of hands to hold the new element in place while you align the holes for the screws in the top of the oven.

Oven Broil Element

Steve from TX

Heading element was worn out/damaged.

Screwdriver and needle nose pliers.

When you detach the wires from the back of the element be careful that the wires don't find their way into the back cavity of the oven.

Oven Broil Element

Robert from UT

Center element of broiler coil would not heat

Crosspoint and flat screwdrivers and needle nose pliers

The element is attached with 4 electrical wires. Pull element out slowly so the wires stay attached. One of the wires came off the element and I had to pull it out of the back of the oven with needle nose pliers.