Halogen Light Bulb

Halogen Light Bulb

Robert from CA

Light burnt out.

Plastic auto body prybar

You ***MUST*** turn off the power to the stove. Once the door is open, if the power is left on, as soon as you plug in the light it will turn on and melt the connectors!!! Other than that, gently use the prybar to pop the glass cover out of the oven, pull out the old light, plug in the new, and replace the cover. Turn power back on and work should be done.

Halogen Light Bulb

George from MI

Oven Bulb burned out

Screwdriver

Oven bulb in Jenn-Air downdraft stove burned out. Getting the bulb out took some thought and analysis. The screw which appeared to hold the glass in place was actually holding the whole fixture. The glass is held in by clips and removed by prying the glass from the fixture. Identifying the correct bulb can be difficult as there are a boatload of Jenn-Air stoves with the same model number. The picture picture of the bulb on the partsdr.com web site was very clear and made identification possible. When installing the new bulb it helps to have the fixture out of the stove so you can see how the conductor pins fit into their respective holes. It's also helpful to remove the oven door when removing and replacing the bulb. I will rate this repair as "kinda difficult" only because it was the first time for me. If the bulb goes out again it will be a very easy repair.

Halogen Light Bulb

Cliff from NY

Replaced oven light bulb

Flashlight, philips and slotted screw driver.

Turn off circuit breaker, remove philips screw, pull out the light housing, be careful with the wiring harness. Use a slotted screw driver on the side tabs to release fronr glass. Put on rubber gloves, remove old bulb, exchange for new bulb, replace light housing. Turn the circuit breaker back on, turn light switch on to test and your down.