Part
High Limit Thermostat
Product Rating
Customer
Robert from CA
Problem
Maytag dryer would not heat, but pilot ignitor was working ok and flame came on but then shut off soon thereafter. Clothes took hours to dry when normal time was about an hour.
Tools
Screw drivers
Repair & Advice
After watching the video, i decided to change the high limit thermostat. I tested the old one using an electronic skillet and meat thermometer and noted it opened the circuit at too low a temp. So i ordered the new switch and replaced it. The problem was not completely solved so i also ordered the solenoids and now the dryer is working perfect. Part was an exact match and easy to change out. Total time for project was longer due to research and cleaning out the dryer which was very over due. But actual part change is about a 15 min job, super easy. 4 screws remove front panel and door and 2 screws for the high limit thermostat. I will be looking inside the dryer every couple years from now on for safety reasons as the lint was quite thick and a fire hazard after 10 years of not checking on it. Good old maytag. I think it's nearly 30 years old and runs like a charm.
Story submitted on January 19, 2015
Part
High Limit Thermostat
Product Rating
Customer
Michael from IL
Problem
Dryer would start warm then just cold.. replacing hi-level thermostat was the problem. Clothes dryed perfectly.
Tools
Phillips head screwdriver
Repair & Advice
Locate hi-temp thermostat. ALWAYS on top or side of heat pipe/chamber. Check with electric sensor for continuity, or just replace. (Just a couple bucks and will need repkacement eventually. ) note:tight spaces to reach screws so use stubby screwdriver or just pull out the drum so you have access to all replacement parts.( dont be afraid to do this. Once all holing hardware is removed (screws) lift out drum grabbing the belt) You tube has nearly every model.. and by watching the the right video its a snap. Then go ahead and replace the belt , and radial heat sensor, thermistor and so on. I rebuilt my Maytag for under $100 and its good for another 12 years (national average life of washer or dryer). Any appliance repairman is 100 before they touch anything, Neighbor was crying to me about replacing their dryer for $600 and he (per my suggestion), replaced the igniter and thermistor..DONE! His x-mas stocking will be full this year.My wife goes"thats one less in the landfill" hmmmmm. I have ordered washer and dryer parts elsewhere, but Parts Dr. has an excellent selection and is fairly priced. Super speedy shipping helps cuz I did my repairs in the living room. Nuff said
Story submitted on December 14, 2016