Sound Insulation

Sound Insulation

Andrew from CA

Sound insulation flap worn out and torn

Fingers and a screw driver

Insulation strip worn out from opening and closing dishwasher. If you're not good with your hands you may need to remove dishwasher door, however, if you're good with your hands you can do this in 10 minutes. Unscrew bottom plate, remove old insulation by unsticking along inside bottom of dishwasher. Line up new insulation, remove tape strip and reapply. Press along to be sure sticky is stuck then pop back bottom plate.

Sound Insulation

Thomas from NY

rubber sound insulation piece under dishwasher was worn out and cracked from a few years of opening/closing the unit.

no tools needed, there is adhesive strip on the part, simple installation

I was looking for this part all over the internet an that's how I found Part Dr. The part arrived within a couple days.

Sound Insulation

Michael from IL

Original sound insulation tore because installer drove kickplate screw into the into the insulation. The insulation is supposed to move freely over the top of the kickplate.

Ratcheting screwdriver with drivers to fit the fasteners on the insider of the door.

The fasteners on the top of the door for the control panel do not need to be removed to take off the outside door cover. You need to support the door cover or it will drop to the floor.