Part
Ice Maker Assembly
Product Rating
Customer
Jordan from NJ
Problem
Ice Maker did not make ice
Tools
Screwdrivers
Repair & Advice
Install went smooth except for 2 hiccups:
1. It took me a few minutes to figure out that I had to pry the cover off sideways after removing the 4 brass screws. It looks like it should lift straight up, but it doesn't work that way. Remove the screws, push it up a bit, then pry from either side.
2. The new molex didn't match with what was in the door. I ended up removing the wires and hooking up the old wires/molex to the new device. It was only 3 wires and 2 of them snapped in.
Even with those diversions it took me less than 30 minutes. Without them it would have been 5.
Story submitted on May 12, 2015
Part
Ice Maker Assembly
Product Rating
Customer
Mark from OK
Problem
Ice maker quit working and could not be reset.
Tools
Flat blade and Phillips screwdriver.
Repair & Advice
Watched a YouTube video prior to making repair. Video made it a quick removal and replacement of the icemaker. The screws reused from the old icemaker guard were a size to big for the replacement icemaker. The screws are metric and can be obtained at a local hardware store.
Story submitted on December 18, 2021
Part
Ice Maker Assembly
Product Rating
Customer
Kevin from MI
Problem
Factory Ice Maker stopped working
Tools
Basic tools.
Repair & Advice
Repair went smooth, part arrived quickly and worked perfectly.
Story submitted on August 9, 2016