Part
Mode Shifter & Shaft
Product Rating
Customer
Mike from AL
Problem
Squealing on spin cycle, turns out motor need replaced also
Tools
Wrenches,
Repair & Advice
Bearings and shaft were squealing come to find out the bearings in the motor was shot also so had to replace the motor also with a new belt getting belt on was a real challenge
Story submitted on October 13, 2016
Part
Mode Shifter & Shaft
Product Rating
Customer
Ralph from NY
Problem
Noise in spin mode.
Tools
GE Spanner wrench with 4 lb short sledge hammer, 1/2 inch socket wrench with 1/2 socket,3/8 socket wrench with 3/8 socket, 7/16 socket 1/4 inch driver and 5/16s driver and putty knife.
Repair & Advice
I am pretty handy and you have the tools it is okay if you are not this may for you. The basket is a little heavy and the tank with the motor on if you need help get it. I watched a video on UTube there are a lot of repair videos (repair clinic, Fix it with Steve etc). and followed step by step instructions once every item is out it’s pretty simple but make sure that the 1/2 nut is very tight on the flywheel also the spanner nut should be very tight also both loosened up for me and I had to disassemble it again and tighten them both up but it is done now and the machine is quiet on spin cycle.
Story submitted on November 28, 2020
Part
Mode Shifter & Shaft
Product Rating
Customer
Tim from NE
Problem
Grinding and loud bangs.
Tools
Sockets and wrenches.
Repair & Advice
Used internet you tube to follow procedure.
Story submitted on March 23, 2021