Main Control Board w/Instructions

Main Control Board w/Instructions

Bruce from MN

Sears tech said it was the board or the lid lock. I, for some reason, ordered the lid lock through Amazon but ordered the wrong lock so ended up just installing the board and it what was wrong. You supplied the board in a timely manner . Sears had it back-ordered.

Impact driver with a 3 to 4-inch extension for 1/4" . Scrapper, 6 or 8" long screwdriver and Phillips. A flashlight too.

Use the flashlight to locate the clips to remove the top lid, they are a little tricky. Honestly, you have to be a little mechanical to do this but for me it was very easy because I enjoy repairing things. This can be done by most people with the help of videos.

Main Control Board w/Instructions

Glen from TX

Lid lock not releasing.

Screwdriver, nut driver.

The wires from/to the lid lock were inadvertently caught on the sheet metal back of the control panel when I replaced the first lid lock. This caused the coil to burn up and thus to not release. This also caused the main board to not send power to the lid lock thus requiring it to be replaced as well.

Main Control Board w/Instructions

Robert from PA

Machine cycles were all off

Screw driver

Slid the board in, plugged it in and VOILA!!!