Part
Water Inlet Valve
Product Rating
Customer
ANGELA from MS
Problem
Washer would overfill and run over.
Tools
Screwdriver and Pliers were used during the repair.
Repair & Advice
This was a very easy repair. Make sure washer is disconnected from your power source. Disconnect your water source. Remove 4 screws from rear plate. Remove 2 screws from the control panel cover. Disconnect the inlet valve wiring and remove 1 screw. Lifts right out.
Story submitted on June 22, 2021
Part
Water Inlet Valve
Product Rating
Customer
Michael from FL
Problem
Washer was filling with water when not in use.
Tools
Screw driver and pliers
Repair & Advice
Washer works like new again, simple to install...
Story submitted on February 25, 2022
Part
Water Inlet Valve
Product Rating
Customer
JASON from ME
Problem
Water inlet valve was pouring Out on the cold side in the valve when not in use
Tools
I used just a Phillips screwdriver
Repair & Advice
The repair was very easily done in about 15 minutes just unscrew The top panel where the control board is located and lift off the panel The inlet water valve is right there in front of you unscrew the two screws to the old one slide the old one out and then slide the new one in and install the two screws and then push panel down and screw those two screws on the side very simple
Story submitted on February 21, 2023