Main Control Board

Main Control Board

Kurtis from TN

The dishwasher would not start-wouldn’t register that the door was closed.

Screwdriver and sockets.

I tried changing out the door switch but still no luck. After searching some more it was recommended to change out the main control board underneath the door. Very easy! About 6 total screws and five simple plugs and it was out. One grounding screw and 4 pins to remove the board. Total time was about 30 minutes and it’s running like normal again. Thanks Part Dr.

Main Control Board

Darrell from AZ

GE dishwasher (GDT695SSJ0SS) would not start.

1/4 inch & 5/16 inch nut drivers; needle nose pliers.

Our 3-year old GE dishwasher would not start. We had a repairman come out earlier in the summer, and I paid him $85 to basically reset the dishwasher, and everything was fine. But he did say if it happens again, the problem would probably be the main circuit board. When it wouldn't start again, I tried resetting it (unplugging). When that didn't work, I bought this main circuit board from Parts Dr. I found a video on youtube from another repair parts site, and used 1/4 inch & 5/16 inch nut drivers to install the new board. The board was pretty accessible at the bottom of the dishwasher, and the repair took about 30 minutes. Good as new!

Main Control Board

William from NC

Dishwasher would only indicate blinking lights while trying to operate.

Screwdriver and pliers

Diagnosed through on-line videos and followed repair advice online