Part
Oven Control Board
Product Rating
Customer
Barry from GA
Problem
Oven control board quit working because the electricity went off numberless time because of storm.
Tools
Screwdriver.
Repair & Advice
Received board and installed matching each wire from old to new. Working fine.
Story submitted on November 28, 2020
Part
Oven Control Board
Product Rating
Customer
Catherine from OR
Problem
Oven control board failed.
Tools
Needle nose pliers to remove circuits, screwdriver to pop off sides of plastic mounts
Repair & Advice
Keypad on oven did not respond to pressure, dead in the water. Looks like this is a common problem with unit, as GE listed a replacement for the original part.. Part appears to be scarce, it was not available from GE or several other online parts stores. Parts Dr. Inc was the only one I found, and for a reasonable price. Thanks so much
Hint: Take a pic of the wire connections, for reassembly, makes it a lot easier.
Story submitted on September 3, 2018
Part
Oven Control Board
Product Rating
Customer
John from VA
Problem
Oven randomly turned off after selecting bake.
Tools
Nut driver, needle nose pliers
Repair & Advice
This was a very easy repair. To ensure accurate reconnection of wires, I disconnected one at a time and connected to the new control panel. The trickiest procedure was releasing the surface controls brackets from the old control panel. To release the brackets I used two small slotted screw drivers to press the locking tabs. Other than bracket challenge, all else was straight forward.
Story submitted on November 24, 2022