Part
8" Surface Burner Switch
Product Rating
Customer
Dana from MA
Problem
Burner went to high heat immediately
Tools
Multi screwdriver
Repair & Advice
I removed the back of the range, removing about 8 hex head screws to expose the burner control. It was easy to remove the connectors from the existing control. Removed the existing control by removing 2 Phillips head screws and the OEM replacement fit right in. This was the only online parts store that had the correct OEM product and the shipping was blazing fast! I'm sure that I will be shopping here again.
Story submitted on October 18, 2019
Part
8" Surface Burner Switch
Product Rating
Customer
Danny from TX
Problem
Burner indicator light was on constantly.
Tools
Phillips screwdriver
Repair & Advice
Very simple find and fix. Checked each switch and until I found the one with the short.
Story submitted on June 11, 2015
Part
8" Surface Burner Switch
Product Rating
Customer
Seth from MA
Problem
Burner would go to straight red hot.
Tools
Screwdriver.
Repair & Advice
Took 5 minutes to do...6 screws off back...pull and place wires on new part and install. Took longer to clean under and around stove.
Story submitted on February 5, 2021