Part
Convection Fan
Product Rating
Customer
Steven from MA
Problem
Not applicable. Using this for an industrial application for a recirculating heating process.
Tools
Hand tools used for installation. Installed in a custom designed and built housing.
Repair & Advice
Our customer needed a small, low temperature (250 to 300 degree) recirculating heater for an adhesive bonding application. This unit provided both heat and fan capability in a single unit with only a 914 watt power requirement and low cost. We integrated this unit into the custom designed system with electronics to precisely control temperature, time and thermal ramp rates.
Story submitted on June 27, 2022
Part
Convection Fan
Product Rating
Customer
Michael from AL
Problem
Fan was making a noise and barely turning.. then quit altogether. SO I opted to replace the assy
Tools
screwdriver, needlenose pliers to assist removing connections .. gloves.. sharp edges
Repair & Advice
Remove the fan from inside the stove, disconnected the connections, installed the new assembly by reconnectiong the power connections, 2, and reinstalling the outer bracket.. works like it should now.
Story submitted on December 2, 2022