Part
Control Board
Product Rating
Customer
Charles from FL
Problem
Bottom heating element in oven not heating.
Tools
Phillips screwdriver
Repair & Advice
Bottom heating element obviously burned out. Once it was replaced it still did not work. After careful troubleshooting it was determined that control board had also failed. Part arrived promptly and replacement took all of 15 minutes. Once replaced the oven is working perfectly. Range is only 4 years old. This was a very economical solution to avoid replacement of a range that was in good condition.
Story submitted on October 12, 2021
Part
Control Board
Product Rating
Customer
Karla from FL
Problem
Range/oven not heating to proper temperature
Tools
Ratchet, sockets
Repair & Advice
Slide out oven from wall , unplug, take off 10 screws back of oven. Took a picture of control board and then following the picture installed new control board
Story submitted on July 13, 2021
Part
Control Board
Product Rating
Customer
Don from TX
Problem
Oven could not heat up to temperature
Tools
Screwdriver
Repair & Advice
The cost to repair from a qualified company was close to $500. Searched for the part online and found PartsDr. Customer service was very helpful and the item shipped the same day as it was ordered. Installation was simple.
Story submitted on October 10, 2019