Track (Left)

Part

• Track (Left)

Product Rating

Customer

Problem

Ball bearings fell out of upper track slide.

Tools

Screwdriver, nut driver and duct tape.

Repair & Advice

Easy job unscrew and pull dishwasher out from under counter. Move insulation back un-screw slide put new slide in. Less than half an hour.

Part

• Track (Left)

Product Rating

Customer

Problem

Dishwasher upper rack track fell apart.

Tools

Wrenches, pliers, screwdrivers

Repair & Advice

Dishwasher must be completely uninstalled. Start by shutting off the power, then begin removing the dishwasher from under the cupboard (if that's where it's located). Before pulling the machine out, remove the upper rack by locating the release tabs on the front of the rack, push them in while lifting up on the rack. When the front of the rack pulls away from the track, gently pull the rack forward and up and it should release completely from the track, repeat for the other side. The screws that hold the rack tracks in place are located on both sides of the machine under the sound proofing material. Remove the screws and replace the track, making sure that the new track is in the right orientation. Install the screws loosely until all 4 are partially threaded in before tightening them down snugly. Reverse the disassembly process and you should be good to go! If your not comfortable doing this, hire a qualified repairman. There are several videos on YouTube that are helpful also. Most of all, take your time and check your work, it's a big job that needs to be done right the first time. Good luck!

Part

• Track (Left)

Product Rating

Customer

Problem

Track for the top drawer of maytag dishwasher basically disintegrated after 5 years of daily use.

Tools

Screwdriver

Repair & Advice

Followed the instructions. Easy peasy.