Part
Suspension Rod Kit
Product Rating
Customer
Edward from TX
Problem
Washer was banging on spin cycle, sometimes even going off balance and canceling the spin cycle.
Tools
Impact driver to go quicker on the screws. Needle nose, and vice grip Pliers for the hoses. And a towel for the water.
Repair & Advice
Actually wasn’t too hard, the hardest part is holding up the internal spinning “bucket” when installing the suspension rods, just a little grease made gripping a little difficult. Recommend using gloves, maybe cloth, with a latex palm gloves, or maybe full latex.
Story submitted on February 19, 2022
Part
Suspension Rod Kit
Product Rating
Customer
craig from PA
Problem
weak springs, tub moved a lot, might have caused the top ring to break.
Tools
nut driver, wire to hold open lid, vise grips to pull spring to insert into keeper
Repair & Advice
You tube had a detailed video!!!
Story submitted on October 18, 2023
Part
Suspension Rod Kit
Product Rating
Customer
Doug from GA
Problem
Washer would vibrate very violently on spin cycle.
Tools
Nut driver.
Repair & Advice
Easy to remove top and replace the suspension rods, Use a tiedown strap for the lid to secure it. Remove the back two rods. place the washer on its front on a towel and remove the back rods. Reverse order to replace with new suspension rod kit.
Story submitted on April 24, 2023