Part
Control Panel
Product Rating
Customer
Adam from SC
Problem
Washer would not stay on
Tools
1/4 nut driver and flathead screwdriver
Repair & Advice
Washer would turn on but no sounds. All settings worked but when started it would run water then spin for about 20 seconds. After that it just shut off with an error code can’t remember what it was. Checked water filters first. Then tested continuity between the touch screen and main control board. That tested good so took a shot and ordered the touch screen. Fixed it
Story submitted on June 22, 2021
Part
Control Panel
Product Rating
Customer
Matthew from PA
Problem
Cabrio washer E3 F6 error codes
Tools
screw driver, allen wrench, putty knife
Repair & Advice
Was having the E3 F6 issue for a few months. We were able to keep the washer limping along by following online advice about cleaning the user interface panel, but the fix was always temporary. The codes would eventually come back. After replacing the interface panel with the new one, the washer has been working great. Much cheaper than a new washer!!
Story submitted on September 6, 2022
Part
Control Panel
Product Rating
Customer
Levi from CO
Problem
Replaced front control panel for washer
Tools
Screwdriver, Philips, and flathead.
Repair & Advice
You have to remove the top of the washer and remove/replace the control panel.
Story submitted on July 27, 2023