Part
Control Console
Product Rating
Customer
Peter from UT
Problem
Washer was giving us an error code F6 E2. After reviewing some online videos of other DIYers we determined this part is what we needed.
Tools
Screw driver, butter knife (thin rigid object)
Repair & Advice
We began by taking off the back panel and let it hang on the hot and cold water intake. The hardest part was getting the control panel off because of some metal clips holding it in. The butter knife was used to slide underneath on each side and push the slips in to release the control panel. Then it was as simple as unplugging the panel from the circuit board and plugging in the new control panel and making sure everything worked before replacing the back cover panel.
Story submitted on October 23, 2019
Part
Control Console
Product Rating
Customer
George from TX
Problem
I had damaged the washer control console
Tools
Cooking spatula
Repair & Advice
I burn up the control console with a heat gun, looked around for part and found it here, best price easy install ordering was fast.
Story submitted on August 10, 2019
Part
Control Console
Product Rating
Customer
Robert from PA
Problem
Control panel stopped working
Tools
5/16 nut driver
Repair & Advice
Very easy to replace a few screws on the back 2 Clips. You can reach from inside where the drum is a little hard to get to and squeeze those clips but you might be able to get them with a puting knife on the outside.
Story submitted on October 12, 2023