Part
Main Control Board
Product Rating
Customer
Bill from MO
Problem
Oven temperature wouldn't control.
Tools
Phillips and flat-bladed screwdrivers
Repair & Advice
I pulled the stove away from the wall, unplugged it, and took out the screws that held the back panel. I removed the panel, which exposed the control board. After taking note the location of the wiring connections, I disconnected them and removed the control board by pushing on the clips which held it in place. I then pushed the new board into place, being careful to keep it right side up. I attached the wiring connectors, re-installed the back panel and the job was done.
Story submitted on January 21, 2023
Part
Main Control Board
Product Rating
Customer
William from TN
Problem
Oven would not heat up
Tools
Screwdriver
Repair & Advice
Oven elements would not turn on, too or bottom. Used electrical test meter to check elements, thermostat and electrical load coming into stove. All were fine. Repair man told me it was likely the controller. Found this part on Parts Dr. for much less than elsewhere. Simple fix. Unplugged components to control board after removing back of stove. Removed two screws to remove the control board. Put new board on its place, plugged up components and wa La , fixed. I did take a picture of how the components plugged back into the control board before I removed the old one. I would recommend that or label the wires. Also ALWAYS unplug stove while servicing it.
Story submitted on February 5, 2022
Part
Main Control Board
Product Rating
Customer
Dragan from AL
Problem
Owen electrical panel would stop working.
Tools
Screwdriver
Repair & Advice
Very easy to replace. Took only 15 min. Great OEM part and work as it should without any issues.
Story submitted on September 6, 2022