Main Control Board

Main Control Board

Bill from MO

Oven temperature wouldn't control.

Phillips and flat-bladed screwdrivers

I pulled the stove away from the wall, unplugged it, and took out the screws that held the back panel. I removed the panel, which exposed the control board. After taking note the location of the wiring connections, I disconnected them and removed the control board by pushing on the clips which held it in place. I then pushed the new board into place, being careful to keep it right side up. I attached the wiring connectors, re-installed the back panel and the job was done.

Main Control Board

William from TN

Oven would not heat up

Screwdriver

Oven elements would not turn on, too or bottom. Used electrical test meter to check elements, thermostat and electrical load coming into stove. All were fine. Repair man told me it was likely the controller. Found this part on Parts Dr. for much less than elsewhere. Simple fix. Unplugged components to control board after removing back of stove. Removed two screws to remove the control board. Put new board on its place, plugged up components and wa La , fixed. I did take a picture of how the components plugged back into the control board before I removed the old one. I would recommend that or label the wires. Also ALWAYS unplug stove while servicing it.

Main Control Board

Dragan from AL

Owen electrical panel would stop working.

Screwdriver

Very easy to replace. Took only 15 min. Great OEM part and work as it should without any issues.