Part
Suspension Rod Kit
Product Rating
Customer
Ato from VI
Problem
Washer was doing the dance and vibrating all over the place.
Tools
1/4" socket and ratchet
Repair & Advice
I removed the screws from the rear backing plate then slid the top of the washer forward so I could lift it up to get to the top portion of the rod springs. Then I layed the washer on its side so I would be able to remove the rods without any obstructions. I did one at a time unlocking each plastic clip holding the rod in place so I could pull out the spring completely. When installing the rods hook the tub centering springs over the rod before putting it all the way through the top and snapping in the plastic clip. You will also have to slightly pry up the top of the basin to hook the other end of the tub centering spring in place. Do the same for the other three.
Story submitted on June 20, 2018
Part
Suspension Rod Kit
Product Rating
Customer
ed from FL
Problem
Unbalanced loads
Tools
Nut driver
Repair & Advice
Changed suspension rods as per instructions(did not wear gloves), cured problem, thank you. Did have some minor cuts on hands which made it seem, to others, of my great repair abilities.
Story submitted on August 31, 2021
Part
Suspension Rod Kit
Product Rating
Customer
Aaron B from HI
Problem
Recently my washer started to become off balance with every load of laundry.
Tools
Tools needed 1/4 inch nut driver and needle nose pliers
Repair & Advice
Replacing suspension rods were pretty easy just removed hood which was also easy since I've repaired other parts on my washer previously. Laid it on its side and replaced the rods one by one. Repair is pretty much straight forward.
Story submitted on December 26, 2023