Part
Handle (White)
Product Rating
Customer
Thor from UT
Problem
The plastic pin on the right side had broken
Tools
I used a special star shaped driver for the screws that secured the front panel.
Repair & Advice
I unscrewed the entire front panel and discovered that the handle was broken or cracked. I ordered a new one and got the electrical panel and handle put back together. What made it difficult was that it all had to be put together before the screws were secured. I also lost one of the special screws and had to go to my local hardware store and find a philips head screw that worked.
Story submitted on May 7, 2017
Part
Handle (White)
Product Rating
Customer
Judith from TX
Problem
Control panel was popping off
Tools
Torque head Screwdriver
Repair & Advice
Easy to fix. Second person helpful to hold front panel in place while replacing screws
Story submitted on September 11, 2021
Part
Handle (White)
Product Rating
Customer
Greg from CA
Problem
Latch and handle broken, control panel stopped functioning
Tools
Torx type screwdriver, very small flathead screwdriver
Repair & Advice
I had to replace latch, handle and control panel, but will briefly describe handle only. 1. Open door and remove torx screws at the top of the dishwasher door and side screws down the sides. You might be able to loosen the bottom screws of the door out but not have to remove. 2. The panels of the door will come apart. Lift off control panel and unplug it at the door, not middle of harness. Set aside. 3. Take screw out of handle, remove, replace with new handle, and screw in place. 4. Plug control panel back in, place on top, insert screws in corner first. Replace all door screws and tighten snuggly without torquing down.
Story submitted on May 1, 2019