Part
Main Control Board
Product Rating
Customer
Shankarnarayanan from VA
Problem
Dishwasher shut off before cycle ended.
Tools
Screwdriver.
Repair & Advice
1. Turn off the dishwasher circuit at the circuit breaker.
2. Unscrew screws on the back of the dishwasher door and the top panel screws in the back.
3. Unplug the top panel and set it aside.
4. Make note of where all the wires are connected to the board. Take a video before you
disconnect all the wires from the board.
5. Disconnect all the wires connected to the board.
6. Remove the thermal fuse from the board and leave it hanging.
7. Unscrew the screw holding the board.
8. Install the new control board by screwing the screw to the rear plate.
9. Connect all the color coded wires as per the original board.
10. Plug back the top panel to the board connector.
11. Fasten the door with screws.
12. Fasten the top panel.
Story submitted on May 11, 2021
Part
Main Control Board
Product Rating
Customer
Ravi from TX
Problem
Washer error codes made no sense
Tools
Simple tools
Repair & Advice
Very easy to replace
Story submitted on October 26, 2021
Part
Main Control Board
Product Rating
Customer
Alexis from NJ
Problem
Control pad was not responding. This happened before when covered by original warranty.
Tools
Screwdriver and a torque driver (star shaped) screwdriver
Repair & Advice
Ended up using old cover for the control board folr better cable management. Straight forward swap.
Story submitted on January 22, 2022