Part
Water Level Pressure Switch
Product Rating
Customer
Rusty from WA
Problem
f02 error, no clogging or water even in washer. drain pump runs and eventually stops with code.
Tools
No tools necessary
Repair & Advice
After selecting wash cycle, door locks goes through pre-checks. Drain pump just runs and runs. eventually stops and posts code on display. initially made sure pump and drain were clear of any potential clogging issues. Replaced drain pump because it was slightly noisy, did not repair problem. Checked sensor line for clogging. I Felt that the ccu was getting erroneous signal that it still had water in unit. No definitive tests could be found to isolate or check level sensor so I took the chance on the sensor being the issue. Ordered Part. Plugged it in, washer has been working flawlessly ever since. Diagnosis took the most time at least 1.5 hrs checking drains, lines, connections etc.
Story submitted on February 2, 2021
Part
Water Level Pressure Switch
Product Rating
Customer
Zelma from NY
Problem
Washer will not fill with water.
Tools
Screwdriver, wrench.
Repair & Advice
Use the manual to troubleshoot and determine the problem.
Story submitted on April 28, 2021
Part
Water Level Pressure Switch
Product Rating
Customer
Zelma from NY
Problem
Washer did not fill with water
Tools
Screwdriver, small wrench
Repair & Advice
Just follow the manual of troubleshooting to isolate the problem.
Story submitted on April 28, 2021