Dishrack Roller Assembly

Dishrack Roller Assembly

kirk from MN

Bottom roller of the top left dishwasher side wall two roller mount broke and the roller wouldn’t stay on.

Phillips screwdrivers and 3/8 socket

Open the dishwasher door, remove the screws that hold the top of the dishwasher to the countertop, pull out the dishwasher approximately 6 inches, pull back the insulation in the area of the roller mount assembly, remove the two screws holding the roller assembly, remove the mount, remove the plastic clip end cap of the top rack rail by squeezing in the clip, slide the new mount on, reattach, move the insulation back into place, push the dishwasher back into place and reattach the screws to the bottom of the countertop.

Dishrack Roller Assembly

Tawnya from AZ

Wheel broke on dish washer rack

Wrench

Very easy tp repair, pulled out washer, took out screws with wrench. I then took off broke wheel assembly, and replaced with new one. Only struggle was undoing water hose in order to pull out dish washer 6 inches in order to get it external screws.

Dishrack Roller Assembly

John from NY

Wheel broke off assembly

Phillips screwdriver

I thought I could just snap it in from the inside. I was wrong had to slide the unit out. So I had a disconnect the water feet on the bottom slide the unit out disconnect the old rollers connected the rollers and put it back together. Turned out to be an easy task!!!