Thermal Fuse and Thermostat Kit

Thermal Fuse and Thermostat Kit

William from NC

Dry won’t turn on or start.

Multi meter on continuity setting to test thermal fuse,. 1/4 inch nut driver and a Phillips screwdriver .

You can go online and watch a few videos on YouTube or Rumble to acquaint yourself with the process. Not difficult at all just make sure to clean all the lint out of the blower tube and front shroud that lint filter goes into cause it will be full lint that’s why you are reading this and your thermal fuse is blown. Cause dryer won’t start. When you get correct parts put them both in not just the one that tested bad. Cheap parts give cheap results (in other words you will be repairing the same part) get real OEM parts at Parts DR. Do the job once and done.

Thermal Fuse and Thermostat Kit

CHARLES from NY

Steamer heater was not working.

Screwdriver, sockets, multimeter.

These came in a set of 3, the one is not the exact sensor so I had to improvise a little but made it work. The other 2 were fine.