Part
Hall Sensor Control Board
Product Rating
Customer
Raul from TX
Problem
Washer Beeps F2 error when push start cycle.
Tools
Screw driver and RPS sensor.
Repair & Advice
I checked all the diagnostic manual says about f2 error; motor is good, water hose clean, motor pump looks good, so what is the problem ?…. Ok I enter to the diagnostic hide menu to run All sensors and motors, I just realize that when I run the motor, it spin for 2 seconds and then it pops the error even when you are in the service hide menu. So my logic was, if I the f2 error is about the motor and the service manual says the first areas I checked , and with the service menu I run the motor it works, that mean everything is fine except my rps sensor, I just ordered and change it and now is working great since 15 days I fixed.
Story submitted on July 10, 2021