Part
Lid Assembly
Product Rating
Customer
PAULA from TX
Problem
The glass on the lid was broken.
Tools
Screwdriver.
Repair & Advice
There are four screws on the sides of the lid. It is a very easy fix.
Story submitted on March 31, 2020
Part
Lid Assembly
Product Rating
Customer
Ryan from TX
Problem
Washer lid broke
Tools
Screwdriver
Repair & Advice
Installed hinges on new lid and placed new lid on washer
Story submitted on September 10, 2019
Part
Lid Assembly
Product Rating
Customer
Matt from AL
Problem
The outer bezel broke due to the spring clip pushing through.
Tools
Phillips head and small flathead
Repair & Advice
You will need two people to do this job. Once you have the (white) bezel off, set the lid on top of the washer in the closed position. Make sure that your spring clips are in position. Snap the front part of the bezel but leave the back part un-snapped so that you can get to the spring clips. Lift the lid into the open position and push the spring clips to align them on the inside bezel. Once lined up, snap the bezel into place in the back. All that is left to at this point is to insert your 4 screws that hold the spring clips to the bezel.
Story submitted on September 12, 2019