Part
Flange Shaft Assembly
Product Rating
Customer
Brian from MA
Problem
Washer made extreme banging on high spin
Tools
Screw gun w/ phillips tip, 3/8 ratchet, assorted extensions, metric sockets up to 19mm
Repair & Advice
After noticing that the washer, on the spin cycle, made loud banging, the first thing I did was look for videos. Looked like the shock absorbers were the easiest solution. After changing these which was not difficult, found that this did not solve the problem. After further research, found that the sound cause may be what they call this part the "spider gear". Well, It's not for the faint of heart, but if you are mechanical, you can do it. Pay close attention to what you take apart, as you will end up pretty much taking the washer down to the frame. I found my spider gear was broken in about 4 places. You will absolutely break the 6 bolts holding it in, so order those in addition to this part.
Story submitted on February 3, 2023
Part
Flange Shaft Assembly
Product Rating
Customer
Jairo from GA
Problem
Unstable drum
Tools
Screwdriver, wrench, mallet
Repair & Advice
Easy installation after washer is put apart. Takes about 5 hours to complete job but results actually worth it.
Story submitted on October 16, 2021
Part
Flange Shaft Assembly
Product Rating
Customer
Jessie from TN
Problem
The flange shaft assembly (spider assembly) was cracked.
Tools
Pliers, rubber mallet, 10mm socket, 13mm socket, 19mm socket, Phillip's screwdriver, and a Kabota tractor to lift the tub to put it back into the machine after replacing the spider.
Repair & Advice
Watched a YouTube on how to replace the Flange Shaft Assembly. You must disassemble the whole tub section of the washer in order to replace the Flange Shaft Assembly (Spider). Lots of screws so I color-coded each scree so I would know where to replace them back into the correct slot. It took 3 hours to disassemble and 5 hours to reassemble since this was the first time ever attempting such a task but the machine worked great once I got it back together.
Story submitted on October 20, 2020