Part
Main Control Board
Product Rating
Customer
Sheila from TX
Problem
Dryer would not stop spinning, and would not heat when spinning.
Tools
Screwdriver
Repair & Advice
Simply removed back cover, unplugged two plugs to display board, unscrewed the housing of old PC board, detached all plugs into PC board, replaced with new replacement board and reattached all connections. Worked perfectly!
Story submitted on July 21, 2021
Part
Main Control Board
Product Rating
Customer
Christina from VA
Problem
Dryer would continue to run cold after drying cycle was completed. If door was shut, it was spinning.
Tools
Screwdriver and handy husband.
Repair & Advice
We ordered the wrong part first from another site. Should have started with Parts Dr which had very clear information on compatible parts/dryer model.
Story submitted on March 15, 2022
Part
Main Control Board
Product Rating
Customer
Kirk from KY
Problem
Tumbling and heating even when turned off.
Tools
Phillips screwdriver.
Repair & Advice
Remove 2 screws in back that hold control hosing on, make sure dryer is unplugged, hinge top toward you and lift. Remove screw holding control board down, unhook all plugs and wires, replace all wires and plugs on new board and install upside down compared to old board. Put back together plug back in.
Story submitted on July 9, 2021