Part
Main Control Board
Product Rating
Customer
Ariel from CA
Problem
Would not power on
Tools
Screwdriver
Repair & Advice
Dryer would not power on. I smelled the “magic smoke” (burnt electronics) so I ordered this part.
Unplug the dryer
Screwdriver to remove the 2 screws at the back to lift off the top metal
Three screws to remove the board from the frame
One screw to remove electronics board from the holder
Plug in the new board
Put everything back with the screws, plug in the dryer and off you go.
Story submitted on February 24, 2022
Part
Main Control Board
Product Rating
Customer
Nicholas from FL
Problem
Dryer would not turn off intermittently.
Tools
Screw driver
Repair & Advice
To replace controller board, unplug unit, take two screws out from rear. Slide top back and off. Top left side gives access to the board. Take cellphone picture of wiring. Replace board following picture.
Story submitted on January 4, 2022
Part
Main Control Board
Product Rating
Customer
Michael from CT
Problem
Dryer does not stop when finished trying. It keeps running until I turn it off. The power finally failed and it won't power up.
Tools
Philip screw driver, voltmeter, flash light.
Repair & Advice
Unplug machine from main power outlet, removed the top so that I could get access to the board. I then took a picture of how the old board is plugged in just to make sure I don't miss anything. Replaced the board with my new board and followed my picture to make sure everything is in correct place. Powered it up and there you go!
Now dryer stops when finished with trying and everything is working fine.
Happy with my purchase.
Story submitted on September 18, 2020