Part
Dispenser Module Assembly
Product Rating
Customer
Thomas from AZ
Problem
Refrigerator and was not working at all. Had to replace module and main computer board in the back of the refrigerator.
Tools
Screwdriver, Prybar, One 1x4 20 inchs long rapped in a bath towel.
Repair & Advice
Unplug refrigerator. Take out one small Phillips scew on the bottom of the module. Place towel wrapped 1x4 flat against the refrigerator door. Put the pry bar tip side up into the module assembly. Make sure the pry bar tip is not in the ice down spout but only in the module assembly. Use the towel wrapped 1×4 that placed flat against the door to pivot off of. It takes about 15 to 25 pounds pressure. Module pops out and then down. Unplug by releasing clip lock and gently pulling the pin connector. Do not pull on the wires. Once released make sure the refrigerator side of the male pin connectors look straight before installing the new unit. Snap in connectors and slide the module up and push the module into door with your hands intell it snaps into place. Reinstall 1 small Phillips screw.
Story submitted on February 26, 2021