Part
Seal
Product Rating
Customer
PETER from TX
Problem
Washer was leaking at the fill tube
Tools
Screw driver
Repair & Advice
The seal between the dispenser and fill tube appear to have been worn and was leaking. At first I tried Flex Seal followed by duct tape to stop the leak. Neither worked, as the water found its way through both the Flex Seal and duct tape. I then opted to replace both the dispenser and the seal. It was not too difficult of a job once I watched the YouTube videos on taking the washer apart for repairs. Once the dispenser and seal were replaced no more leaks and the machine is now a OK.
Story submitted on February 8, 2016
Part
Seal
Product Rating
Customer
Robert from FL
Problem
Washer had hard to find leak.
Tools
Simple hand tools to disassemble top and front panel of washer.
Repair & Advice
Hard to find leak. After verifying no leaks at pump and pump discharge, noticed water dripping from above. Upon further investigation found leak at the seal between dispenser tray feed tube to wash drum. Process to replace very simple following detailed instructions offered on numerous u tube videos. Total time for disassembly, installation and reassembly 1 to 2 hours.
Story submitted on June 1, 2021