Part
Spark Module
Product Rating
Customer
Donald from IN
Problem
Burners would not ignite.
Tools
Phillips screwdriver.
Repair & Advice
1. Disconnect stove from power supply and turn off the gas supply.
2. Remove 4 phillips head screws from back upper panel and remove the panel.
3. Remove 1 phillips screw from the bottom of the igniter module, slide it down to remove the upper mounting tab from the stove side panel.
4. Disconnect wires one at a time from the old module and connect to the same locations on the new module.
5. Repeat steps 3 through 1 to complete the repair, and try igniting the burners to confirm that the issue is resolved.
Story submitted on June 20, 2020
Part
Spark Module
Product Rating
Customer
Dave from MN
Problem
Spark igniter for burner stopped working
Tools
Screwdriver
Repair & Advice
Pulled stove from wall and removed top back panel. Removed screws holding igniter and transferred wires to new piece. Screwed new piece in place and re-installed back panel.
Story submitted on November 5, 2019
Part
Spark Module
Product Rating
Customer
Darrell from AZ
Problem
No spark to stove top burners
Tools
putty knife, nut drivers, pliers, contact cleaner for switches under gas valve.
Repair & Advice
Be careful when removing glass top, make sure seal at edge of glass is completely removed and replace with a very thin rubber at edge of glass when replacing to counter top. Check for gas leaks where you disconnected gas line. Make sure it's tight when reconnecting. Use drop cord and test for spark and all burners before installing to counter top.
Story submitted on October 18, 2022