Spark Module

Spark Module

Donald from IN

Burners would not ignite.

Phillips screwdriver.

1. Disconnect stove from power supply and turn off the gas supply. 2. Remove 4 phillips head screws from back upper panel and remove the panel. 3. Remove 1 phillips screw from the bottom of the igniter module, slide it down to remove the upper mounting tab from the stove side panel. 4. Disconnect wires one at a time from the old module and connect to the same locations on the new module. 5. Repeat steps 3 through 1 to complete the repair, and try igniting the burners to confirm that the issue is resolved.

Spark Module

Dave from MN

Spark igniter for burner stopped working

Screwdriver

Pulled stove from wall and removed top back panel. Removed screws holding igniter and transferred wires to new piece. Screwed new piece in place and re-installed back panel.