Part
Clock Control Board
Product Rating
Customer
william from CA
Problem
The clock on my Jenn-Air range stopped working (along with other controls)
Tools
Screwdriver, cleaning towel, Windex.
Repair & Advice
This was about a ten minute repair. Straight forward, easy to figure out and it only took this long because I cleaned everything while doing the replacement. I took off the door off the range to make access easier. Unscrewed all the Philips head screws under the control panel and pulled from the bottom forward to slide out and unplug. Removed the defective control board, screwed in the replacement, replaced the connectors, returned the upper housing to the original position, tested and then reattached all of the screws. Cleaned everything, reinstalled the door and I was finished.
Story submitted on August 5, 2016
Part
Clock Control Board
Product Rating
Customer
Martin from WA
Problem
Electric oven part of stove (gas burners) was not functioning.
Tools
I used only a phillips screw driver and one 1/4" wrench
Repair & Advice
I suspected the electronic comtroler not working, ordered a replacement part, put it in in about twenty minutes and voilá, a functining oven. A lot cheaper than a replacement appliance.
Story submitted on January 4, 2017
Part
Clock Control Board
Product Rating
Customer
Byron from MD
Problem
Oven failed to heat. Stove top burner starter click very slow
Tools
None
Repair & Advice
Reading online I see that the control panel controls the oven. I ordered a new control panel board and had it installed. The device worked for approximately 2 weeks then oven failed to heat again. I called for replacement and am told it is the oven relay that is probably bad. Online help was not clear as to what controls oven. Even the manual I received with purchase of oven says clock panel controls oven. Although customer service was quite nice he could not give me details of how oven works and how to troubleshoot issues.
Story submitted on July 18, 2017