Part
Blower Motor
Product Rating
Customer
George from PA
Problem
Motor quit working
Tools
Screwdriver, nut driver
Repair & Advice
It takes a little time to align the 3 rubber isolators that are between the motor and the motor housing..... also try not to strip the threads on the studs that mount the motor housing to the unit... the stud in upper rear is a real bear.... dont forget to use the foam gasket around the motor between the motor hsg....takes a bit of time to clean grease from the squirrel cage and unit.
Story submitted on November 6, 2019
Part
Blower Motor
Product Rating
Customer
LEON from AK
Problem
Blower motor stopped working on Jenn Air cooktop.
Tools
Allen wrench, screwdriver, nut driver, pliers.
Repair & Advice
Once removing the motor/fan housing under the counter, the removal and replacement of the fan was very simple. It is helpful to mark the pieces when disassembling them.
Story submitted on May 20, 2022
Part
Blower Motor
Product Rating
Customer
Michael from TX
Problem
Downdraft exhaust fan making too much noise & slow in turning on
Tools
Screwdriver, nut drivers, wire stripper
Repair & Advice
Removed downdraft exhaust fan & replaced bed motor
Story submitted on September 11, 2018