Part
Heating Element Kit
Product Rating
Customer
Tony from CA
Problem
Dryer would not heat
Tools
Phillips screwdriver, wire cutter
Repair & Advice
This repair was really easy to correct. All I had to do was disconnect the power, remove the lower panel on the dryer by taking two screws out. Reaching towards the back of the dryer and removing two screws that hold the heating element in place and slide it down and out. Once it’s out, I disconnected the two power wires and plugged the new one in and reassembled it.
There are videos on YouTube to help if you’re in doubt.
Story submitted on January 25, 2023